A clutch linkage installation kit for a Fuller manual transmission to be installed into a Kenworth T660, T800B, T800, T800W, W900B and W900L trucks with a Big Block Engine. This kit is ideal when completing a transmission swap such as replacing an automated transmission with a manual transmission. The kit includes all components needed to install the release yoke in the bell housing of the transmission and the correct clutch linkage rods, levers and brackets to connect the left side cross shaft exiting the side of the transmission to the bell crank lever.
Kit Includes:
- Right Side Cross Shaft
- Left Side Cross Shaft
- Clutch Release Yoke
- (2) Yoke Cap Screw
- (2) Cross Shaft Washer Key
- Clutch Release Lever - Side of Transmission
- Clutch Rod - Clutch Lever on Transmission to Side of Frame
- Clutch Lever Bracket - Frame Mounted
- Clutch Rod - Clutch Lever on Frame to Bell Crank
- Clutch Release Lever - Frame Bracket to Bell Crank
- Bell Crank Lever
NOTE: A Mid block engine would typically be 10-13 liter with the exception of Detroit 12.7. Big block engine would typically be 14+ liter.
